Products

JFoam™ A-204 is used in radome fabrication, antenna filling, structural panels, and aircraft control sections. A-204 is not to be used where cross section is greater than three inches. A-204 has a small uniform cell structure and a low viscosity at pour point.

JFoam™ A-206 is used in radome fabrication, antenna filling, structural panels, and aircraft control sections. A-206 is not to be used where cross section is greater than three inches. A-206 has a small uniform cell structure and a low viscosity at pour point

JFoam™ A-216 is used in radome fabrication, antenna filling, structural panels, and aircraft control sections. A-216 is not to be used where cross section is greater than three inches. A-216 has a small uniform cell structure and a low viscosity at pour point.

JFoam™ AC-555 is a two-component water blown polyurethane foam system, which can be used for large void filling applications. The foam produced from AC-555 has been shown to meet or exceed all criteria for MIL-P-24249.

JFoam™ BH-610 is for use in potting electronic units, aircraft and missile control surfaces, insulation, and structural panels. BH-610 is designed primarily to operate in the 300-400°F temperature range and is not to be used where cross section is greater than three inches. BH-610 has a large and irregular cell structure and a viscous pour point.

JFoam™ BH-614 is for use in potting electronic units, aircraft and missile control surfaces, insulation, and structural panels. BH-614 is designed primarily to operate in the 300-400°F temperature range and is not to be used where cross section is greater than three inches. BH-614 has a medium and slightly irregular cell structure and viscous pour point.

JFOAM™ BX-190-R is the resin component of a two part polyurethane system, which when combined with the T component, Isocyanate, will produce a water-blown rigid polyurethane foam system. BX-190 is used for void fill and core material applications and can meet some military specifications.

JFoam™ BX-273-8 is a two component rigid urethane system designed for use in radome fabrication, antenna filling, structural panels, and aircraft control sections.

JFoam™ BX-300 is an all water blown, rigid polyurethane / polyisocyanurate foam system, which can be used for pour in place applications

JFoam™ BX-450 is a two component, water blown polyurethane modified polyisocyanurate foam designed for structural core applications. BX-450 exhibits excellent high temperature properties and can operate continuously at temperatures up to 350°F.

JFoam™ BX-590-R is the resin component of a two part polyurethane system, which when combined with the T component, isocyanate, will produce a water blown rigid polyurethane foam system. BX-590 can be used in a variety of specialized medium density molding and void filling applications.

JFoam™ BX-600-R is the R component of a two component polyurethane system, which when combined with the T component produces a high density polyurethane foam. The foam product satisfies all of the requirements of the fine furniture industry for applications in cabinetry doors, end-pieces, picture frames, plaques, etc. This system has been shown to give improved moisture resistance, low reject rate under humid conditions, high impact strength, fast mold wet-out, better flow, and fast demold.