Knowde Enhanced TDS
Identification & Functionality
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Key Attributes
- UL Recognized
- Provides effective EMI/RFI shielding over a broad frequency range
- Mild solvent system, safe on polystyrenes
- Does not contain toluene, xylene, or MEK
- Available in liquid format.
Applications & Uses
- Markets
- Applications
- Application Method
- Compatible Substrates & Surfaces
- Recommended Preparation
Clean the substrate with Isopropyl Alcohol, MG #824, so the surface is free of oils, dust, and other residues.
Application Instructions
- Shake the can vigorously.
- Spray a test pattern to ensure good flow quality.
- Tilt the board at 45° and spray a thin, even coat from a distance of 20–25 cm (8–10 in). Use spray-andrelease strokes with an even motion to avoid paint buildup in one spot. Start and end each stroke off the surface.
- Wait 3 min before applying another coat, to avoid trapping solvent.
- Rotate the board 90° and spray again to ensure good coverage.
- Apply additional coats until desired thickness is achieved (go to step 3).
- Let dry 3 min at room temperature before applying heat cure.
- After use, clear the nozzle by inverting the can and briefly spraying until clear propellant comes out.
Properties
- Physical Form
- Physical Properties
- Typical Properties
- Cured Properties
- Uncured Properties
| Value | Units | Test Method / Conditions | |
| Density | 0.99 | g/mL | — |
| Value | Units | Test Method / Conditions | |
| Viscosity (at 25 ˚C) | 87 | cP | — |
| Calculated VOC | 404 | g/L | — |
| Value | Units | Test Method / Conditions | |
| Resistivity | 2.2 x 10⁻⁴ | Ω·cm | — |
| Surface Resistance (at 50 μm) | 0.08 | Ω/sq | — |
| Service Temperature Range | -40 to 120 | ˚C | — |
| Value | Units | Test Method / Conditions | |
| Percent Solids | 16 | % | — |
Regulatory & Compliance
- Certifications & Compliance
- Quality Standards
Technical Details & Test Data
- Shielding Attenuation
Test performed with a two-coat thickness.
- Cure Instructions
Allow to dry at room temperature for 24 hours, or after letting sit for 3 minutes, cure the paint in an oven for 30 minutes @ 65 ˚C.
- Surface Resistance by Paint Thickness
- Usage Parameters
Recoat Time 3 min Cure Times 24 h @ 22 ˚C 30 min @ 65 ˚C Recommended Film Thickness 50–65 μm Minimum Film Thickness 30 μm Theoretical Coverage @ 2 mil
(based on 100% transfer efficiency)23290 cm2
Packaging & Availability
- Packaging and Supporting Products
Cat. No. Packaging Net Volume Net Weight 843AR-340G Aerosol 400 mL 340 g
Storage & Handling
- Shelf Life
- 3 Years
- Storage
Store between -5 and 40 ˚C in a dry area, away from sunlight .