Knowde Enhanced TDS
Identification & Functionality
- Fillers Included
- Polymer Name
- Technologies
Features & Benefits
- Labeling Claims
Applications & Uses
- Applications
- Compatible Polymers & Resins
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
Properties
- Color
- Mechanical Properties
- Physical Properties
- Thermal Properties
- Typical Properties
- Processing Information (Injection Molding)
- Rheological Properties
| Value | Units | Test Method / Conditions | |
| Tensile Strength (Type 2) | 4.0 | MPa | ISO 37 |
| Tear Strength (Method Ba) | 16.0 | kN/m | ISO 34-1 |
| Elongation at Break (Type 2) | 400.0 | % | ISO 37 |
| Shore Hardness A (15s) | 40.0 | — | ISO 868 |
| Tensile Stress at 100% Elongation (Type 2) | 1.5 | MPa | ISO 37 |
| Value | Units | Test Method / Conditions | |
| Density | 930.0 | kg/m³ | ISO 1183 |
| Value | Units | Test Method / Conditions | |
| Compression Set (22h, at 70°C, 25%, Type A) | 30.0 | % | ISO 815 |
| Compression Set (22h, at 100°C, 25%, Type A) | 30.0 | % | ISO 815 |
| Compression Set (72h, at 22°C, 25%, Type A) | 25.0 | % | ISO 815 |
| Compression Set (72h, at 125°C, 25%, Type A) | 40.0 | % | ISO 815 |
| Value | Units | Test Method / Conditions | |
| Service Temperature (depending on load, geometry, etc.) | - 40 to 125 | °C | — |
| Moisture Content | max. 0.1 | % | — |
| Value | Units | Test Method / Conditions | |
| Back Pressure (hydraulic) | min. 3 | bar | — |
| Mould Temperature | 10 - 60 | °C | — |
| Melt Temperature | 190 - 220 | °C | — |
| Holding Pressure (of injection pressure) | 50 - 70 | % | — |
| Injection Speed | Middle - High | — | — |
| Value | Units | Test Method / Conditions | |
| Spiral Flow (2 mm wall thickness) | 40.0 | cm | — |
Regulatory & Compliance
Technical Details & Test Data
- Pre-Drying Conditions
In a dry air (dessiccant) dryer 70-80 °C for 2-4 h
Storage & Handling
- Storage Conditions
Store in dry, tighlty sealed protected from light not above 30°C.