Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Specific Features
- 1-component system
- Adhesion on metal substrate
- Condensation-curing
- Easy handling and dosing
- Excellent adhesion
- Fast curing at room temperature
- Flexible at low (-40 °C) and high temperatures (+150 °C)
- Media resistant
- Non-slump
- One-component
- Sag resistant
- Thixotropic
Applications & Uses
- Application Area
- Cure Method
- Application Details
- Surfaces to be bonded must be clean, dry and free of oils and grease. ELASTOSIL® A 2000 can be bulk dispensed with conventional drum and pail extruder pumps to feed gasket tracing machines for precise bead placement and material efficiency.
- Manual applications for repair, short runs or low volume applications may be accomplished with a pail extruder equipped with a high pressure flexible fluid hose and extrusion gun.
- Recommended equipment suppliers for transfer systems and dispensing machines will be supplied upon request. For most gasket applications, a sealant bead of 3 to 4 mm width is sufficient. Assemble parts immediately so that the sealant is spread.
Properties
- Appearance
- Red paste
- Typical Properties
Value Units Test Method / Conditions Keil Extrusion Rate Keil 400 seconds - Skin Formating Time (at 25°C, 50% r.h) 10 minutes WSTM-2118 Tack-Free Time (at 25°C, 50 % r.h) 15 minutes - - Oil Resistance Properties
Value Units Test Method / Conditions Elongation (at break, 1008 hours, 150°C, Texaco 2224 Hypoid Gear Lubricant) 150 % WSTM 1118 Shore Hardness A (1008 hours, 150°C, Texaco 2224 Hypoid Gear Lubricant) 19 - WSTM-1118 Tensile Strength (1008 hours, at 150°C, Texaco 2224 Hypoid Gear Lubricant) 1 N/mm² WSTM-1118 Volume Swell (at 150°C, 1008 hours,Texaco 2224 Hypoid Gear Lubricant) 10 % - - Cured Properties
Value Units Test Method / Conditions Continuous Service Temperature 150 °C - Elongation (at break) 300 % WSTM 1228 Shore Hardness A 45 - WSTM-1110 Specific Gravity (at 25°C) 1.52 g/cm³ - Tensile Strength 2.1 N/mm² WSTM-1228 Tensile Strength 300 psi WSTM-1228 - Properties
- One-component, room temperature cure
- Non-slump, unaffected by shear
- Adheres to most substrates without priming
- Resistant to hot lubricating oils
- Note
- Curing Conditions: Cured 7 days at 25°C and 50% relative humidity.
- Oil resistance Conditions: 1008hr/150°C
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
Packaging & Availability
- Country Availability
- Regional Availability