Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Special Features
- Addition Curing
- Compressible
- Fast curing under heat
- Foam
- Non-slump
- One-component
Applications & Uses
- Markets
- Applications
- Application Area
- Cure Method
- Applications
- Cured-In-Place-Gaskets (Dry Type)
- Measurement & Control, Sensor Technology
- Application Details
- General-purpose sealant
- FIPG and CIPG applications
Processing
Surface preparation:
All surfaces must be clean and free of contaminants that will inhibit the cure of ELASTOSIL® RT 713. Examples of inhibiting contaminants are sulfur containing materials, plasticizers, urethanes, amine containing materials and organometallic compounds – especially organotin compounds. If a substrate’s ability to inhibit cure is unknown, a small scale test should be run to determine compatibility.
Dispensing:
Because of the high thixotropy (shear thinning effect) ELASTOSIL® RT 713 can be dispensed easily with all dispensing equipments.
Curing:
- ELASTOSIL® RT 713 works best when cured at 115 °C or more depending on the size and heat sink properties of the components.
- ELASTOSIL® RT 713 shows good primerless adhesion to many substrates (metals, glass, ceramics, plastics). We recommend running preliminary tests to optimize conditions for the particular application.
Temperature Curing rate, 1cm
100 °C 4 h 130 °C 30 min 150 °C 10 min
Properties
- Physical Form
- Cured Properties
Value Units Test Method / Conditions Density (at 23°C) 0.75 g/cm³ DIN EN ISO 1183-1 A Elongation (at break) 300 % ISO 37 Type 1 Shore Hardness A 23 - DIN ISO 48-4 Tear Resistance 7 N/mm ASTM D 624 B Tensile Strength 1.5 N/mm² ISO 37 Type 1 - Uncured Properties
Value Units Test Method / Conditions Density approx. 0.75 g/cm³ DIN 53479 Dynamic Viscosity 80000 mPa·s - Dynamic Viscosity (at 23°C, Shear rate 25 s⁻¹) 80000 mPa·s ISO 3219 - Properties
- Ready-to-use, one-part system
- Non-slump
- Rapid heat cure
- Low density
- Low hardness
- High compressibility
- Primerless adhesion to many substrates
- Note
Cured for 30 min at 150 °C in a circulating air oven for cured properties.
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
Safety & Health
- Safety Note
According to the latest findings, the addition-curing silicone rubber ELASTOSIL® RT 713 contains neither toxic or corrosive substances which would require special handling precautions.
Packaging & Availability
- Country Availability
- Regional Availability