Knowde Enhanced TDS
Identification & Functionality
- Carrier
- Chemical Family
- Technologies
- Product Families
Features & Benefits
- Materials Features
- Specific Features
- Cold-shrinkable
- Electrically conductive
Applications & Uses
- Markets
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Applications
Cable Accessories
- Application Details
POWERSIL® 466 A/B is suitable for production of electrically conductive injection molded articles, especially cable accessories in the medium and high voltage range. The range of use spreads from push-on accessories to cold shrink applications. POWERSIL® 466 A/B combines a low Shore A durometer with high elongation, good setting properties (low tension set) and good mechanical properties which are a must for cold shrink applications.
Processing
Components A and B are delivered ready to use in drums of 20 and 200 liters capacity. They can be pumped by means of standard metering equipment from these drums and mixing in a static mixer straight into the heated mold. The mixing ratio is 1 : 1. At room temperature, mixtures of A and B components have a pot life of at least three days.
Properties
- Catalyst Properties
- Cured Properties
- Uncured Properties
- Properties
- High elongation at break, low tension set
- Stable electrical properties
- Good mechanical properties
- Ready-to-use, two-component system
- Note
Cured Properties: Cure conditions: 5 min / 165°C in press; Postcuring 4 h / 200°C.
Value | Units | Test Method / Conditions | |
Dynamic Viscosity (A+B, Shear rate 10 s⁻¹) | 550000 | mPa·s | DIN EN ISO 3219 |
Kick-Off Temperature (A+B) | 125 | °C | — |
Pot Life (A+B, at 23°C) | 3 | days | — |
Value | Units | Test Method / Conditions | |
Compression Set (at 22 hours, 175°C) | 11 | % | DIN ISO 815-1 type B method A |
Density | 1.08 | g/cm³ | DIN EN ISO 1183-1 A |
Elongation (at break) | 650 | % | ISO 37 Type 1 |
Modulus (at 100 % elongation) | 0.75 | N/mm² | ISO 37 Type 1 |
Modulus (at 300 % elongation) | 2.6 | N/mm² | ISO 37 Type 1 |
Shore Hardness A | 38 | — | DIN ISO 48-4 |
Tear Strength | 28 | N/mm | ASTM D 624 B |
Tensile Strength | 7 | N/mm² | ISO 37 Type 1 |
Tension Set | 2.6 | % | ISO 2285 |
Volume Resistivity | 30 | Ohm-cm | IEC 62631-3-1 |
Value | Units | Test Method / Conditions | |
Dynamic Viscosity (Component A, Shear rate 10 s⁻¹) | 600000 | mPa·s | DIN EN ISO 3219 |
Dynamic Viscosity (Component B, Shear rate 10 s⁻¹) | 500000 | mPa·s | DIN EN ISO 3219 |
Mix Ratio (A:B) | 1:1 | parts by weight | — |
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Country Availability
- Regional Availability
- Packaging Information
This product is available in 20 kg pail and 200 kg drum kits.