Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Compatible Substrates & Surfaces
- Application Details
- Surfaces to be primed should be dry and free from grease, oil or other contaminants. The surface should first be cleaned with a non-polar solvent such as mineral spirits (at a boiling range of 80 °C up to 140 °C), followed by a polar solvent, preferably acetone. Loose particles must be removed, and very smooth surfaces should be roughened by grinding. The primer is best applied with a brush, although dipping or spraying can also be used. On relatively smooth, non-absorbent surfaces such as aluminum, the primer should be applied as thinly as possible and free of air bubbles.
- On very rough or absorbent surfaces, such as plywood, the coating should be applied quite liberally. The reaction time of the primer film is at least 1 hour at ambient temperature (relative atmospheric humidity must be at least 40 % and should be monitored using a hygrometer) or 10 minutes at 100 °C (the latter only applies to metallic substrates). The catalyzed silicone rubber should be applied to the primer coat immediately after the drying or heating process, if possible, but at the latest after 5 hours since otherwise a drop in adhesive strength may occur. Important Maximum adhesive strength will only be achieved after 4 days. But usually after 24 hours sufficient adhesion will have developed to allow pad demolding without any problems.
- Once opened, containers of WACKER® G 795 should be kept well sealed and stored in a cool and dry place. Bonding agent preferably used with addition-curing RTV-2 silicone rubbers from, among others, the ELASTOSIL® M and ELASTOSIL® RT ranges to achieve adhesion to metallic and non-metallic substrates. Even silicone rubber formulations modified with large amounts of silicone fluid, of the kind commonly used for making printing pads, will develop excellent adhesion to aluminum or plywood carrier plates when WACKER® G 795 is used.
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Active Substance | 18 | wt % | - |
| Dynamic Viscosity | approx. 2 | mPa·s | - |
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Safety Notes
Due to its high content of aliphatic hydrocarbons, WACKER® G 795 is subject to the same safety regulations as these, i. e., it is flammable liquid (flash point 25 °C). Appropriate precautions are an absolute must.
Packaging & Availability
- Country Availability
- Regional Availability