Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Polymer Name
- Technologies
- Product Families
Features & Benefits
- Materials Features
- Specific Features
- Addition Curing
- BfR compliant
- Fast curing at room temperature
- FDA compliant
- Flowable
- Low viscosity
- No chemical shrinkage
- Two-component
Applications & Uses
- Markets
- Cure Method
- Plastics & Elastomers End Uses
- Applications
- Making molds for concrete casting.
- Reproduction Molding
- Application Details
- Due to its good resistance to all common reproduction materials. e.g. casting resins, concrete, as well as the superior mechanical properties, CENUSIL® M 825 A/B is especially suitable for all molds of models with extensive undercuts.
- As a low-Shore A addition silicone rubber that cures without undergoing dimensional shrinkage, CENUSIL® M 825 A/B is also suitable if absolutely accurate copies of models are required.
Properties
- Catalyst Properties
- Cured Properties
- Uncured Properties
- Properties
- Excellent flowability and self-deaeration
- High tear strength
- Low hardness (Shore A 25)
- Mixing ratio of 1:1 for straightforward processing
- Fast and non shrink cure at room temperature which can be accelerated considerably by the application of heat
- Excellent long-term stability of the mechanical properties of the vulcanizate
- Good resisitance to common reproduction materials
| Value | Units | Test Method / Conditions | |
| Demoldable (A+B, at 23°C) | 6 | hours | — |
| Mix Ratio (A:B) | 1:1 | parts by weight | — |
| Pot Life (A+B, at 23°C, up to 60000 mPa.s) | 60 | minutes | DIN EN ISO 2555 |
| Value | Units | Test Method / Conditions | |
| Elongation (at break) | 450 | % | ISO 37 Type 1 |
| Shore Hardness A | 25 | — | DIN ISO 48-4 |
| Tear Strength | 20 | N/mm | ASTM D 624 B |
| Tensile Strength | 5 | N/mm² | ISO 37 Type 1 |
| Value | Units | Test Method / Conditions | |
| Density (at 23°C, Componenet A) | 1.05 | g/cm³ | DIN EN ISO 2811-1 |
| Density (at 23°C, Componenet B) | 1.05 | g/cm³ | DIN EN ISO 2811-1 |
| Dynamic Viscosity (Component A, at 23°C) | 8000 | mPa·s | ISO 3219 |
| Dynamic Viscosity (Component B, at 23°C) | 8000 | mPa·s | ISO 3219 |
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Safety Notes
Components A and B of the addition-curing grade CENUSIL® M 825 A/B contain only constituents that over many years have proved to be neither toxic nor aggressive. Special handling precautions are therefore not required, i.e., only the general industrial hygiene regulations apply.
Packaging & Availability
- Country Availability
- Regional Availability
- Packaging Information
- CENUSIL® M 825 A 20 KG HOBBOCK PE
- CENUSIL® M 825 A 200 KG DRUM SB
- CENUSIL® M 825 B 20 KG HOBBOCK PE
- CENUSIL® M 825 B 200 KG DRUM SB