company tower banner
Wacker Chemie AG Company Logo
ELASTOSIL® E4 is a non-slump, acetoxy-cure, one-component silicone rubber that cures at room temperature under the influence of atmospheric moisture. It exhibits good heat stability, with permanent temperatures up to 180°C and peak temperatures up to 200°C. This product has excellent primerless adhesion to many substrates.

Product Type: 1K (1 component) Sealant

Application Area: Gaskets

Cure Method: Air Dry, Chemical Cure, Moisture Cure

Chemical Family: Silicones

Technical Data Sheet

Knowde Enhanced TDS

Identification & Functionality

Chemical Family

Features & Benefits

Specific Features
  • Non-slump
  • One-component

Applications & Uses

Application Area
Applications
  • Appliances Industry
  • Bonding & Sealing
  • Cured-In-Place-Gaskets (Dry Type)
  • Formed-In-Place-Gaskets (Wet Type)
  • Industrial Assembly
  • Ready-to-Use Silicone Sealants - General Applications
Application Details

Multipurpose sealant and adhesive where low hardness/low modulus is needed for high movement capability.

Processing

ELASTOSIL® E4 shows good primerless adhesion to many substrates. We recommend running preliminary tests to optimize conditions for the particular application.

Properties

Cured Properties
ValueUnitsTest Method / Conditions
Density (in water, at 23°C)1.02g/cm³DIN EN ISO 1183-1 A
Elongation (at break, Type 3, 23°C, 2mm)750%ISO 37 Type 1
Shore Hardness A15DIN ISO 48-4
Tensile Strength (Type 3, at 23°C, 2mm)2N/mm²ISO 37 Type 1
Uncured Properties
ValueUnitsTest Method / Conditions
Curing Time (at 23°C, 50 %r.h)12hour/mm
Density1.01g/cm³DIN EN ISO 1183-1 A
Skin Formating Time (at 23°C, 50% r.h)20minutes
Properties
  • Acetoxy-cure RTV-1
  • Low Shore A hardness
  • Excellent primerless adhesion to many substrates
  • Good heat stability: permanent temperatures up to 180°C and peak temperatures up to 200°C
Note

Curing Conditions: 14 days at 23°C and 50 % relative humidity, 2 mm sheet, no post-curing.

Regulatory & Compliance

Certifications & Compliance

Safety & Health

Safety Notes

During vulcanization of ELASTOSIL® E4, a total of 3% by weight of acetic acid is split off. These vapors should not be inhaled for long periods or in high concentration. Work areas should therefore be well ventilated. Contact of unvulcanized silicone rubber with eyes and mucous membranes must be avoided as this would cause irritation. However if it does happen, rinse the affected area thoroughly with water.

Packaging & Availability

Country Availability
Regional Availability
  • Africa
  • Asia
  • Europe
  • Latin America
  • Middle East
  • North America
  • Oceania