Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Materials Features
- Ready-to-Use Product Features
- Special Features
- 1-component system
- Self-leveling
- Shear thinning
Applications & Uses
- Markets
- Applications
- Application Method
- Cure Method
- Application Details
General-purpose potting and coating grade for technical applications.
Processing
- ELASTOSIL® N2010 is a ready-to-use, acid- and solvent-free, non-corrosive RTV-1 (room temperature vulcanizing, 1-component) silicone rubber suitable for many applications. Good adhesion to plastics and metals in combination with a elasticity and durability open up a wide range of potential uses.
- The consistency of the uncured material allows processing by dipping, spraying, dispensing. ELASTOSIL® N2010 exhibits outstanding resistance to weathering, aging, moisture, and UV light.
- The vulcanized silicone rubber permanently remains elastic over a wide temperature range from -50°C to +180°C (-58 to +356°F). If removing of silicone rubber from machines or dispensing equipment is necessary, white spirit is recommended as a solvent. However, cleaning should take place before the rubber is fully cured.
Properties
- Typical Properties
Value Units Test Method / Conditions Recommended Service Temperature -45 to +180 °C - - Cured Properties
Value Units Test Method / Conditions Density (at 23°C) 1.01 g/cm³ DIN EN ISO 1183-1 A Elongation (at break) 200 % ISO 37 Shore Hardness A 25 - DIN ISO 48-4 Tensile Strength (Type 3, at 23°C, 2mm) 1 N/mm² ISO 37 - Uncured Properties
Value Units Test Method / Conditions Density 1.01 g/cm³ DIN EN ISO 1183-1 A Dynamic Viscosity (Shear rate 0.5 s⁻¹) 15 mPa·s ISO 3219 Dynamic Viscosity (Shear rate 25 s⁻¹) 10 mPa·s ISO 3219 Skin Formating Time (at 23°C, 50% r.h) 20 minutes - - Properties
- Neutral curing system (alkoxy)
- Translucent
- Sprayable
- Primerless adhesion to many substrates
- Solvent free
- Note
Curing Conditions: 14 days at 23°C and 50% relative humidity, 2 mm sheet, no post-curing.
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
Safety & Health
- Safety Note
ELASTOSIL® N 2010 releases during cure about 3% methyl alcohol. These vapors should not be inhaled for long periods or in high concentrations. Hence good ventilation of the works place is necessary.
Packaging & Availability
- Country Availability
- Regional Availability